Bones
Formo team · 17 April 2026
Hello,
This week our drawings got a skeleton. Literally.
Why bones?
Imagine you have drawn a jellyfish and want its tentacles to sway. Each tentacle is three pieces: a top, a middle and a tip. Without bones you turn the top, then move the middle back under it, then the tip under that — on every tentacle, on every single frame. Miss by a few pixels and the tentacle falls apart. Animators have a word for this kind of work, and it is not a nice one.
Puppets solved this problem long ago. A puppet's parts are joined, so when you turn the top of a limb, everything below turns with it. You only think about the movement, never about keeping the pieces together.
Bones bring that idea to your drawings. You draw as usual, put a skeleton inside the drawing, and from then on you move the skeleton — the drawing follows.
Drawing a skeleton
The Skeleton tool lives in Animate mode. Switch to it and simply drag on the canvas: where you press is where the bone starts, where you let go is where it ends. That is your first bone. Draw it inside the shape it should carry, with a little room to the edges, and the shape is attached to it.
Now drag again, starting from the end of that bone. The new bone grows out of the first one. Keep going and you get a whole chain: from the body into the top of a tentacle, then the middle, then the tip.
While you draw, the bone that the next one will grow from is highlighted, so you always know where you are. Want a new branch — the next tentacle? Start your drag on the end of any bone, and the new bone grows from there. Or press Escape to step back up the chain to the parent bone. Press Enter when the skeleton is done.
Drag, drag, drag — a tentacle in three gestures. Start from any bone's end to branch.
Limbs that move together
A skeleton is only useful if the drawing comes with it. A shape attached to a bone moves, turns and scales with it — and because bones are joined, it also follows every bone above it.
So when you turn the top bone of a tentacle, the top segment turns. The middle segment hangs from the middle bone, which hangs from the top one, so it turns too — and keeps its own bend. The tip follows the middle. Nothing slides apart, and you never line up a single piece by hand again.
It also works from the other end. Grab the tip of a tentacle and drag it somewhere: the bones above it bend on their own so that the tentacle stays in one piece.
Turn the top and the whole tentacle follows. Pull the tip and the bones above work out the bend.
Tip: sometimes you want the opposite — turn the top bone but keep the tip pointing roughly where it was. Hold Alt while you turn with the rotate handle, and the bones below lean back towards their old angle. Hold Ctrl+Alt and they keep it exactly. Hold Shift to turn in neat 15° steps.
Hotkeys: Ctrl+3 — Animate mode · Escape — step up to the parent bone · Enter — finish the skeleton · Alt while turning — the bones below resist the turn · Ctrl+Alt — they keep their angle · Shift — 15° steps
Draw a skeleton into one of your old drawings and give it a sway. We would love to see what moves first.
As always, let us know what you think on our Discord.