Posing a skeleton

Formo team · 24 April 2026

Hello,

A week ago we gave your drawings a skeleton. This week we make it move.


Rotate, then keep

Select a bone in Animate mode and a ring appears around its joint. Grab the ring and turn: the bone swings, and every bone and every piece of drawing attached below it rides along. That is posing.

Posing works together with the timeline. Turn on Auto, move the playhead, strike a pose, and a keyframe is written for you. Do it again a few frames later and the drawing moves from one pose to the other, with the in-between worked out for you. Posing is undoable like everything else, so you can try a pose and step back.

A swimming jellyfish is a nice example, because the motion is a wave that runs down the tentacles. You need just four poses. On frame 8, lean the top bone of every tentacle the same way. On frame 16, bring the tops back and lean the middle bones. On frame 24, bring the middles back and lean the tips. On frame 32, bring the tips back, and the loop closes. Each pose is simple; together the bend travels from the body down to the tips.

Video

Four simple poses, one level at a time, and the tentacles wave on their own.

Bones are not limited to a half turn either: you can rotate a bone more than 180 degrees, so a full swing works without tricks.


Pull the tip, the tentacle follows

Turning every joint one by one is how real puppeteers think, but sometimes you know where the tip should go and not how each bone above it should turn. That is what IK (inverse kinematics) is for: you say where the end goes, and the chain works out how to get there.

Pick the bone at the end of the chain, and in the Properties panel set its IK target. Any shape in the document can be a target: a ball the tentacle reaches for, or a spot you mark. Pick it from the list, search it by name, or click it right on the canvas. From then on the chain bends so that its end reaches the target. Move the target and the chain follows. When the target is too far, the chain simply stretches straight towards it.

Video

Give the tip a target and the tentacle figures out the bend.

IK works on two bones: the one with the target and the one it hangs from, such as a forearm and an upper arm. Bones higher up the chain stay where they are. With a single bone the same setting simply rotates that bone to the target.

Video

Two bones bend to reach. One bone just points.

Hotkeys: Ctrl+3 — Animate mode · Space — Play / Stop


Make something reach for something. Not too far, though. Chains have limits, and we would like to hear how it feels when you find them.

As always, let us know what you think on our Discord.

On this page

Formo

The browser studio where drawings become animations, toys, and games. Your files, nothing to install.