Reshape the ink

Formo team · 21 August 2026

Hello,

Drawing a line is half the job. The other half is saying "a little more curve here, thicker there". This week the brush got tools for the second half.


Sculpt: push the line like clay

Think of a bit of wet clay on a table. You do not remove it and form it again; you press your thumb into it. The Sculpt tool does that to your drawing. Pick it, drag over your strokes, and the lines and the fills between them flow with your cursor. The fill follows what you see, so there is no gap between a line and its colour.

There are four ways to push, shown as small icons in the panel:

  • Push moves the ink along with your drag.
  • Twirl swirls it around the cursor.
  • Pinch pulls it together towards the centre.
  • Bloat puffs it outwards.

Radius and strength are two sliders in the panel, and you can resize the ring on the fly by holding Alt and turning the mouse wheel. One drag is one undo step, so a messy push is a single Ctrl+Z away.

Push the mouth into a smile, then take it back.


Edit the points of a stroke

Sometimes you want the opposite of clay: exact control. Double-click a stroke in Draw mode and you step into point editing. The centre line of the stroke is a smooth chain of curve points, and there are far fewer of them than the pen produced, so a hand-drawn line is easy to adjust: drag a point, pull a handle. The width and timing of the stroke are kept as you edit. Escape first clears the selected point; press it again and you are back in Draw mode, exactly where you were.

Width: drag the edge of the ink

While you edit a stroke, move the cursor to the edge of the ink. It turns into a resize cursor. Drag, and the line gets thicker or thinner at that spot. Widths are set per place on the stroke, so you can have a thin entry, a fat belly and a tapered tail, as a calligrapher would.

Double-click, adjust the curve, widen the belly, Escape.


The Draw panel, split in two

The Draw panel was getting crowded, so it is now split into the tools and the details of the tool you are using. Each sub-tool shows only its own options: the bucket shows its Gap, the sculpt shows its radius and strength.

Hotkeys: Ctrl+2 — Draw mode · W — Sculpt · 1 / 2 / 3 / 4 — sculpt modes · Alt+wheel — sculpt radius · Double-click a stroke — edit its points · Escape — back to Draw · G — bucket


Draw a face with two lines and a circle, then give it a smile with the Sculpt tool.

As always, let us know what you think on our Discord.

On this page

Formo

The browser studio where drawings become animations, toys, and games. Your files, nothing to install.